NVG 243-NP1

Removal Procedure





1. Remove the lower instrument panel trim.
2. Remove the two screws securing the transfer case control module to the bracket.
The bracket is mounted on the I/P reinforcement.
3. Remove the electrical connector from the transfer case control module.

Installation Procedure





1. Install the electrical connector to the transfer case control module.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the two screws securing the transfer case control module to the bracket.
Tighten the transfer case control module screws to 8 Nm (71 ft. lbs.).
3. Install the lower instrument panel trim.