Fuse Block Replacement

REMOVAL PROCEDURE

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.

1. Disconnect the negative battery cable.
2. Remove the necessary instrument panel end cap.
3. Disable the SIR. Refer to Disabling the SIR System.
4. Unsnap the fuse block from the instrument panel bracket.
5. Disconnect the electrical connectors.
6. Remove the fuse block from the vehicle.

INSTALLATION PROCEDURE
1. Connect all the electrical connectors.
2. Install the fuse block to the fuse block bracket, snap it into place.
3. Enable the SIR. Refer to Enabling the SIR System.
4. Install the instrument panel end cap.
5. Connect the negative battery cable.