Backup Lamp Switch: Service and Repair

Removal Procedure






1. Disconnect the connector (2) from the backup lamp switch.
2. Remove the backup lamp switch wire from the retaining clamp.
3. Remove the backup lamp switch (1) from the left case.
4. Inspect the backup lamp switch O-ring for cuts or for damage.
5. Replace the O-ring if necessary.

Installation Procedure

Notice: Refer to Fastener Notice in Service Precautions.






1. Install the backup lamp switch (1) into the left case.
Tighten the backup lamp switch to 23 Nm (17 ft. lbs.).
2. Install the backup lamp switch wire into the retaining clamp.
3. Connect the connector (2) to the backup lamp switch.