Two-Door

REMOVAL PROCEDURE
1. Remove the following items from the front seat:
^ The bolt
^ The washer
^ The spacer
^ The front seat belt buckle (4)
2. Remove the following components:
^ The lower anchor bolt that retains the front seat belt
^ The washers
^ The spacer
3. Open the cover, and remove the following components:
^ The anchor bolt that retains the upper guide loop (1) of the front seat belt
^ The washers
^ The spacer
4. Remove the lower rear quarter trim panel.
5. Remove the following items from the vehicle:
^ The screw
^ The bolt that retains the front seat belt retractor
^ The washers
^ The front seat belt retractor (2)

INSTALLATION PROCEDURE

NOTE: Refer to Fastener Notice in Service Precautions.

1. Install the front seat belt retractor (2) to the vehicle. Secure the retractor with the following fasteners:
- The screw
- The washers
- The spacer
- The bolt that retains the front seat belt retractor

Tighten
Tighten the seat belt retractor bolt to 45 N.m (33 lb ft).

2. Install the front seat belt guide loop (1) to the center pillar. Secure the guide loop with the anchor bolt.

Tighten
Tighten the guide loop anchor bolt to 45 N.m (33 lb ft).

3. Install the lower anchor bolt that retains the front seat belt.

Tighten
Tighten the lower anchor bolt to 45 N.m (33 lb ft).

4. Install the front seat belt buckle (4) to the front seat. Secure the buckle with the one bolt.

Tighten
Tighten the seat belt buckle bolt to 45 N.m (33 lb ft).

5. Install the lower rear quarter trim panel.