Power Steering Pressure Switch: Service and Repair

REMOVAL PROCEDURE
1. Disconnect the electrical connector from the Power Steering Pressure (PSP) switch (1).
2. Remove the PSP switch (1) from the high pressure power steering line above the power steering pump (2).

INSTALLATION PROCEDURE

NOTE: Refer to Component Tightening Notice in Service and Precautions.

1. Install the PSP switch (1) into the high pressure power steering line above the power steering pump (2).

Tighten
Tighten the PSP switch to 21 N.m (15 lb ft).

2. Connect the PSP switch electrical connector.