To Close

To close the power sunroof from the:
^ Open position pressing and holding the sunroof switch forward will apply voltage through the close/tilt up circuit to the sunroof module. The close/tilt up input to the module needs to have constant voltage applied (switch pressed) to allow the motor to drive the sunroof glass until it reaches the closed position. The wind deflector will retract prior to the sunroof glass reaching the fully closed position. To close the sunshade, this will have to be manually slid closed.
^ Vent position - pressing and holding the sunroof switch rearward, will apply voltage through the open/tilt down circuit to the sunroof module. The open/tilt down input to the module needs to have constant voltage applied (switch pressed) to allow the motor to tilt the sunroof glass down to the fully closed position.