Throttle Position Sensor: Service and Repair

THROTTLE POSITION (TP) SENSOR REPLACEMENT

REMOVAL PROCEDURE




1. Disconnect the throttle position (TP) sensor electrical connector.




2. Remove the TP sensor attaching screws.

NOTE: The TP sensor is an electrical component. Do not soak the TP sensor in any liquid cleaner or solvent, as damage may result.

3. Remove the TP sensor.

INSTALLATION PROCEDURE




1. Install the TP sensor on the throttle body with the throttle valve in the closed position. Make sure the TP sensor lever lines up with the TP sensor drive lever on the throttle shaft.

NOTE: Refer to the Fastener Notice in Service Precautions.

2. Install the TP sensor attaching screws.

Tighten
Tighten the TP sensor attaching screws to 2 N.m (18 lb in).




3. Connect the TP sensor electrical connector.