Multifunction Turn Signal Lever Replacement

Multifunction Turn Signal Lever Replacement - On Vehicle
Removal Procedure
1. Verify that the multifunction turn signal lever is in the center of the OFF position.
2. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Starting and Charging.
3. Disable the SIR system. Refer to Disabling the SIR System in Restraint Systems.
4. Remove the steering wheel. Refer to Steering Wheel Replacement.
5. Remove the steering column trim covers. Refer to Steering Column Trim Cover Replacement - On Vehicle.





6. Remove the steering column wire harness (1) from the steering column wire harness retainer (2).
7. Remove the two wire harness straps from the steering column wire harness (1).
8. Remove the steering column bulkhead connector from the vehicle wire harness.
9. Disconnect the connectors from the multifunction turn signal lever steering column bulkhead connector.





10. Remove the retaining bolts (1) from the multifunction turn signal lever (2).
11. Remove the multifunction turn signal lever (2) from the steering column.

Installation Procedure





1. Install the multifunction turn signal lever (2). Use a small flat-blade in order to compress the electrical contact and move the multifunction turn signal lever into position.
2. Verify that the electrical contact rests on the canceling cam.

Notice: Refer to Fastener Notice in Service Precautions

3. Install the retaining bolts to the multifunction turn signal lever.
Tighten the retaining bolts to 7 Nm (62 inch lbs.).
4. Connect the gray and black connectors to the multifunction turn signal lever steering column bulkhead connector.
5. Connect the steering column bulkhead connector to the vehicle wire harness.





6. Install the two wire harness straps to the steering column wire harness (1).
7. Install the steering column wire harness (1) to the steering column wire harness retainer (2).
8. Install the steering column trim cover. Refer to Steering Column Trim Cover Replacement - On Vehicle.
9. Verify that the lever is in the center or the OFF position.
10. Install the steering wheel to the steering column. Refer to Steering Wheel Replacement.
11. Enable the SIR system. Refer to Enabling the SIR System in Restraint Systems.
12. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Starting and Charging.