Headlamp Switch: Service and Repair

REMOVAL PROCEDURE

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.




1. Disconnect the battery negative cable.
2. Remove the instrument panel cluster trim plate.
3. Remove the switch from the plate by using the following procedure:
3.1. Release the retaining tabs on the sides of the switch.
3.2. Pull the switch out of the plate.
3.3. Disconnect the electrical connector(s) at the back of the headlamp switch.

INSTALLATION PROCEDURE




1. Connect the electrical connector(s) to the back of the switch.
2. Install the headlamp switch to the plate by snapping the switch into place.
3. Install the instrument panel cluster trim plate.
4. Connect the battery negative cable.