Power Door Lock Switch: Service and Repair

REMOVAL PROCEDURE

NOTE: Refer to Apply Protective Coating at Insertion Point Notice in Service Precautions.




1. Pry up the rear edge of the drivers side accessory panel (3), and or the front edge of the passenger side accessory panel.
2. Slide the drivers side accessory panel (3) rearward, and or the passenger side accessory panel forward, out of the door trim panel.
3. Disconnect the electrical connector (7) from the power door switch (2).
4. Remove the power lock switch (2) from the accessory panel (3).

INSTALLATION PROCEDURE




1. Install the power lock switch (2) to the accessory panel (3).
2. Connect the electrical connector (7) to the power door switch (2).
3. Insert the front edge of the drivers side accessory panel (3), and or the rear edge of the passenger side accessory panel, into the door trim panel.
4. Press the rear edge of the drivers side accessory panel (3), and or the front edge of the passenger side accessory panel until fully seated.