Alternator: Service and Repair
GENERATOR REPLACEMENTREMOVAL PROCEDURE
1. Disconnect the negative battery cable.
2. Disconnect the generator electrical connections.
3. Remove the drive belt.
4. Remove the generator bolts.
5. Remove the generator.
INSTALLATION PROCEDURE
1. Install the generator.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the generator bolts.
Tighten
^ Tighten the generator bolt (lower) to 50 N.m (37 lb ft).
^ Tighten the generator bolt (upper) to 30 N.m (22 lb ft).
3. Install the drive belt.
4. Connect the generator electrical connections.
5. Connect the negative battery cable.