Backup Lamp: Service and Repair

REMOVAL PROCEDURE




1. Open the rear compartment.
2. Remove the bulb/socket from the backup lamp.
3. Remove the bulb from the socket, if required.
4. Disconnect the electrical connector (5) from the backup lamp.
5. Remove the nuts (1) from the backup lamp.
6. Remove the backup lamp from the rear compartment lid.

INSTALLATION PROCEDURE




1. Install the bulb to the socket, if required.
2. Install the bulb/socket to the backup lamp.
3. Connect the electrical connector (5) to the backup lamp.

NOTE: Note the correct routing of the electrical wiring. Failure to reinstall the wiring properly could result in damage to the wiring.

4. Position the backup lamp to the rear compartment lid.

NOTE: Refer to Fastener Notice in Service Precautions.

5. Install the nuts (1) to the backup lamp.

Tighten
Tighten the backup lamp nuts to 2 N.m (18 lb in).

6. Close the rear compartment.