Carpet Replacement - Front

Carpet Replacement - Front

Removal Procedure




1. Remove the seat.




2. Remove the door sill trim plate.




3. Remove the accelerator pedal stop bracket (drivers side only).




4. Remove the drivers foot rest, (drivers side only).




5. Remove the floor kick-up panel (passenger side only).




6. Pull the carpet back and disconnect the air duct (passenger side only).
7. Pull the intermediate carpet from under lock pillar trim and reposition up out of the way.
8. Pull the carpet from under the instrument panel and accessory trim plate.
9. Pull the seat electrical connector down through the carpet (if equipped).
10. Remove the carpet.
11. Remove the carpet air outlet, if necessary, by turning the air outlet counterclockwise.

Installation Procedure




1. Position the carpet over the floor.
2. Install the carpet air outlet into the carpet (passenger side only).

1. Rotate the air outlet 45 degrees counterclockwise and insert the outlet into the front of the carpet.
2. Rotate the air outlet 45 degrees clockwise to lock in position.

3. Connect the air duct to the carpet air outlet (passenger side only).
4. Tuck the carpet under the accelerator pedal (drivers side only).






Notice: Refer to Fastener Notice in Service Precautions.

5. Install the accelerator pedal stop, (drivers side only).

Tighten the accelerator pedal stop nuts to 10 N.m (89 lb in).




6. Install the drivers foot rest, (drivers side only).

Tighten the foot rest nuts to 10 N.m (89 lb in).




7. Tuck the carpet under the instrument panel and accessory trim plate.
8. Pull the seat electrical connector through the slit in the carpet.




9. Install the floor kick-up panel (passenger side only).




10. Install the side sill trim plate.
11. Reposition the intermediate carpet over the floor carpet.




12. Install the seat.