Weatherstrip Retainer - Roof Lift Off Panel Rear (Side)

Weatherstrip Retainer - Roof Lift Off Panel Rear (Side)

Removal Procedure




1. Remove the roof lift off panel.




2. Remove the weatherstrip from the side retainer and from the first 150 mm (6 in) of the center retainer.




3. Remove the screws attaching the side retainer.
4. Remove the side retainer.

Installation Procedure






Important: A minimum of 2 mm (0.08 in) of sealing foam must extend beyond the ends of the retainer to prevent water leaks.

1. Install foam sealing tape to a reusable retainer or peel the protective cover from the foam tape on a new retainer.
2. Position the retainer.

Notice: Refer to Fastener Notice in Service Precautions.

Important: Stripped, broken, or improperly seated screws must be replaced or repaired to prevent water leaks.

3. Install the screws attaching the retainer.

Tighten the roof weatherstrip retainer screws to 3 N.m (27 lb in).




4. Apply a 6 mm (0.25 in) X 100 mm (4 in) bead of thumb grade sealer to the roof bow and lock pillar overlapping the side retainer as shown.




5. Install the weatherstrip.




6. Install the roof lift off panel.