2. Crankshaft Balancer Removal

Crankshaft Balancer Removal

Tools Required
^ J41816 Crankshaft Balancer Remover
^ J41816-2 Crankshaft End Protector
^ J42386-A Flywheel Holding Tool

Notice: Refer to Fastener Notice in Service Precautions.

Important:
^ For manual transmission applications, note the position of the crankshaft balancer before removal. The balancer does not use a key or keyway for positioning. Mark or scribe the end of the crankshaft and the balancer before component removal. The crankshaft balancer must be reinstalled to the original position.
If replacing the crankshaft balancer, note the location of any existing balance weights, if applicable. Install new balance weights into the new crankshaft balancer, if applicable. Crankshaft balancer weights must be installed into the new balancer in the same location as the old balancer. A properly installed balance weight will be either flush or below flush with the face of the balancer.
^ Do not reuse the crankshaft balancer bolt. Install a NEW crankshaft balancer bolt during final assembly.
^ Make sure that the teeth of the flywheel holding tool mesh with the teeth of the engine flywheel.





1. Install the J42386-A and bolts.
Use one M10-1.5 x 120 mm and one M10-1.5 x 45 mm bolt for proper tool operation.
Tighten the J42386-A bolts to 50 Nm (37 ft. lbs.).





2. Remove the crankshaft balancer bolt.
Do not discard the crankshaft balancer bolt. The balancer bolt will be used during the balancer installation procedure.





3. Mark or scribe the crankshaft balancer and the end of the crankshaft.
Note the balancer installed position on the crankshaft for assembly.





4. Use the J41816 and the J41816-2 in order to remove the crankshaft balancer.
5. Remove the J42386-A and bolts.





6. Note the position of crankshaft balancer weights, if applicable.