Inflatable Restraint Instrument Panel Module Replacement

REMOVAL PROCEDURE

CAUTION: Refer to SIR Inflator Module Handling And Storage Caution in Service Precautions.




1. Disable the SIR system. Refer to: Air Bag(s) Arming and Disarming.
2. Remove the IP upper trim pad.
3. Remove the Connector Position Assurance (CPA) from the IP module harness connector.




4. Disconnect the pigtail connector from the inflatable restraint IP module.




5. Remove the mounting fasteners (3) from the inflatable restraint IP module.
6. Remove the inflatable restraint I/P module (1) from the bracket (2).
7. Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required retention period. Refer to Inflator Module Handling and Scrapping.

INSTALLATION PROCEDURE




1. Install the inflatable restraint IP module (1) to the bracket (2).

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the inflatable restraint IP module mounting fasteners (3).

Tighten
Tighten fasteners to 10 N.m (89 lb in).




3. Connect the pigtail connector to the inflatable restraint IP module.




4. Install the CPA to the harness connector on the inflatable restraint IP module.
5. Install the IP upper trim pad.
6. Enable the SIR system. Refer to: Air Bag(s) Arming and Disarming.