Bracket Replacement - Knee Bolster (Driver)

REMOVAL PROCEDURE




1. Remove the console.
2. Remove the IP accessory trim plate.
3. Remove the driver knee bolster trim panel.
4. Release the ignition switch and hazard warning switch wiring harness retainers from the driver knee bolster bracket.

IMPORTANT: The following step must be performed to assure proper trim fits during installation.

5. Mark the location of the driver knee bolster bracket. Refer to IP Disassembly Precautions
6. Remove the screws retaining the driver knee bolster bracket to the steering column bracket.
7. Remove the driver knee bolster bracket.

INSTALLATION PROCEDURE




1. Install the driver knee bolster bracket into position as marked prior to removal.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the screws which retain the driver knee bolster bracket to the steering column bracket.

Tighten
Tighten the driver knee bolster bracket retaining screws to 1.9 N.m (17 lb in).

3. Secure the ignition switch and hazard warning switch wiring harness retainers to the driver knee bolster bracket.
4. Install the driver knee bolster trim panel.
5. Install the IP accessory trim plate.
6. Install the console.