Electronic Column Lock Module

Electronic Column Lock Module Replacement - On Vehicle (Non-Telescoping)

- Tools Required
- J 42640 Steering Column Lock Pin

Removal Procedure

Important: If the steering column connectors are disconnected with the ignition in the ON position, the BCM will enter a fail enable mode and prevent steering column lock operation. The PCM will also inhibit vehicle motion by disabling fuel. To clear the BCM fail enable mode, disconnect the BCM fuse #25 for 15 seconds.





1. Remove the upper and lower steering column trim covers
2. Remove the wire harness straps (2) from the steering column tilt head assembly (1) and the column.
3. Install J 42640 to the steering column.
4. Remove the steering column tilt head assembly.
5. Remove the electronic column lock module.

Installation Procedure





1. Install the electronic column lock module.
2. Route the wire harness assembly along the steering column jacket assembly.
3. Remove J 42640 from the steering column.





4. Install the wire harness assembly (1) into the wire harness strap (2).





5. Install new wire harness straps (2) to the steering column assembly (1) and the column.
6. Install the steering column tilt head assembly.
7. Install the upper and lower steering column trim covers