Instrument Panel (IP) - Extension Replacement - Luxury
REMOVAL PROCEDURE
1. Remove the console bezel.
2. Remove the driver information center (DIC).
3. Remove the CD player.
4. Remove the console bin.
5. Remove the amplifier, if equipped.
6. Remove the bolts retaining the console to the mounting bracket.
7. Remove the 2 bolts (1) retaining the console to the extension.
8. Carefully lift the front of the console up and then rearwards.
9. Disconnect any wire connections that prevents further rearward movement.
10. Move the console rearwards in order to make room for the IP extension to be removed.
11. Disconnect the wire connector to the extension.
12. Remove the 4 screws (1) that retains the extension to the IP.
13. Ensure all wires are disconnected from the extension.
14. Remove the extension from the vehicle.
15. Remove the speakers from the extension, if equipped.
16. Remove the DIC and power outlet bracket from the extension.
INSTALLATION PROCEDURE
NOTE: Refer to Fastener Notice in Service Precautions.
1. Install the DIC and power outlet bracket to IP extension.
Tighten
Tighten the bracket screws to 1.6 N.m (14 lb in).
2. Install the speaker.
3. Install the extension to the IP.
4. Install the 4 retaining screws.
Tighten
Tighten the screws to 1.6 N.m (14 lb in).
5. Connect the wire connector and attach to the extension.
IMPORTANT: Verify that the wire or connector is NOT outside the console.
6. Carefully move the console forward to attach to the extension.
7. Install the console to the extension by slightly lifting up over the extension hooks and then downwards.
8. Install the 2 retaining screws.
Tighten
Tighten the screws to 1.6 N.m (14 lb in).
9. Connect the wire connectors and attach to the console to prevent rattling during vehicle movement.
10. Install the bolts retaining the console to the mounting bracket.
Tighten
Tighten the bolts to 3.5 N.m (31 lb in).
11. Install the amplifier, if equipped.
12. Install the console bin.
13. Install the CD player.
14. Install the DIC.
15. Install the console bezel.