Steering Shaft, Lower Bearing & Jacket - Assemble

Steering Shaft, Lower Bearing, and Jacket - Assemble - Off Vehicle (Floor Shift Standard)

Notice: Refer to Fastener Notice in Service Precautions.





1. Attach the steering column support assembly (2) to the steering column jacket assembly (3) with 4 new TORX (R) head screws (1).
- Tighten the screws to 17 Nm (13 ft. lbs.).





2. Install the steering shaft assembly (1) into the steering column support assembly (2) and the steering column jacket assembly (3).





3. Install the adapter and bearing assembly (1) onto the steering column jacket assembly.
3.1. Align the tab on the adapter and bearing assembly (1) with the slot in the steering column jacket assembly.
3.2. Push the adapter and bearing assembly (1) onto the steering shaft assembly until the tab snaps into the slot.
4. Install the turn signal and multifunction assembly.
5. Install the electronic lock module assembly.
6. Install the steering column info the vehicle.
7. Install the steering wheel onto the steering column.
8. Enable the inflatable restraint steering wheel module.