Coil Spring Replacement

Coil Spring Replacement

Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Support the rear axle.





3. Disconnect the Real Time Damping (RTD) sensor, if equipped.





4. Remove the stabilizer shaft link retaining nut from the frame.





5. Remove the lower shock absorber nut and bolt from the rear axle.
6. Lower the rear axle until the springs are fully unloaded.
7. Remove the coil spring and the upper insulator.

Installation Procedure





1. Install the coil spring and the upper insulator.
2. Raise the rear axle.

Notice: Refer to Fastener Notice in Service Precautions.





3. Install the lower shock absorber retaining nut and bolt to the rear axle.
Tighten the lower shock absorber retaining nut and bolt to 95 Nm (70 ft. lbs.).
4. Install the stabilizer shaft link to the frame.





5. Install the stabilizer shaft link retaining nut.
Tighten the stabilizer shaft link retaining nut to 65 Nm (48 ft. lbs.).
6. Connect the RTD sensor, if equipped.
7. Remove the rear axle support.
8. Lower the vehicle.