Emergency Vehicle Interior Switch Replacement

REMOVAL PROCEDURE




1. Remove the trim plate bezel from the instrument panel (I/P) cluster.
2. Remove the headlamp switch assembly screws.
3. Pull the headlamp switch assembly from the I/P.




4. Disconnect the electrical connector from the emergency vehicle interior switch.




5. Remove the emergency vehicle interior switch from the back of the headlamp switch assembly.

INSTALLATION PROCEDURE




1. Install the emergency vehicle interior switch through the back of the headlamp switch assembly by pressing the switch into place until fully seated.




2. Connect the electrical connector to the emergency vehicle interior switch.




3. Install the headlamp switch assembly to the I/P.

NOTE: Refer to Fastener Notice in Service Precautions.

4. Install the headlamp switch assembly screws.

Tighten
Tighten the screws to 2 N.m (18 lb in).

5. Install the trim plate bezel.