Accelerator Pedal: Service and Repair
ACCELERATOR CONTROLS PEDAL REPLACEMENTREMOVAL PROCEDURE
1. Remove the left instrument panel sound insulator.
2. Remove the accelerator cable (5) from the accelerator pedal (1).
3. Remove the accelerator pedal bolt (2) and the stud (3).
4. Remove the accelerator pedal (1) from the cowl (4).
INSTALLATION PROCEDURE
1. Install the accelerator pedal (1) to the cowl (4).
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the accelerator pedal bolt (3) and the stud (2).
Tighten
Tighten the bolt and the stud to 5 N.m (44 lb in).
3. Install the accelerator cable (5) to the accelerator pedal (1).
4. Inspect for complete throttle opening and closing positions by operating the accelerator pedal. The throttle should operate freely and without binding between full-closed and wide-open throttle. Inspect for proper carpet fit under the accelerator pedal.
5. Install the left instrument panel sound insulator.