Column Shift

Removal Procedure





1. Remove the knee bolster bracket.
2. Remove the shift lever actuator.
3. Disconnect the electrical connector from the automatic shift lock control actuator.
4. Remove the actuator from the steering column ball studs.

Installation Procedure





1. Install the automatic shift lock control actuator onto the steering column ball studs.
2. Connect the electrical connector to the actuator.
3. Install the shift lever actuator. Place the column in the neutral position.





4. Adjust the automatic shift lock control activator.
^ Pull out the tab (1) on the adjuster block side (2) of the actuator.
^ Press on the adjuster block (2) in order to compress the internal adjuster spring and disengage the adjuster teeth. Slide the adjuster block as far away from the actuator as possible.
^ Lock in place by pushing in on the tab (1).
5. Inspect the actuator.
^ The actuator must lock the shift lever clevis when you place the clevis in the park position.
^ If you can move the shift lever without pressing on the brake pedal, readjust the actuator.
6. Install the knee bolster bracket.