Keyless Entry Transmitter Battery: Service and Repair

REMOVAL PROCEDURE




1. Insert a small coin between the 2 halves of the transmitter case at the slot provided near the key ring hole.
2. Twist the coin in order to open the case.
3. Open the transmitter case.

NOTE: Refer to Handling ESD Sensitive Parts Notice in Service Precautions.




4. Remove the battery.

INSTALLATION PROCEDURE




1. Install the battery with the positive (+) side up. Use one 3 V CR2032 battery (or the equivalent).
2. Ensure that the seal is in position. Align the 2 halves of the case and snap the two halves together.
3. Resynchronize the transmitter. Refer to Transmitter Synchronization. Programming and Relearning