Transfer Case Motor/Encoder Replacement

Transfer Case Motor/Encoder Replacement

Removal Procedure





1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the transfer case shield.





3. Remove the motor/encoder electrical connector.





4. Remove the motor/encoder mounting bolts.
5. Remove the motor/encoder assembly.
6. Remove the motor/encoder gasket.

Installation Procedure

Important: The motor/encoder gasket does not have to be replaced if the motor/encoder is being removed from the transfer case for other service procedures. Replace the motor/encoder gasket only if damaged. If the motor/encoder is being replaced, a new gasket will come with the replacement motor/encoder.





1. Install the motor/encoder gasket.

Important: When performing this service procedure, make sure that the motor/encoder unit is flat against the transfer case for proper installation.





2. Install the motor/encoder to the transfer case.

Notice: Refer to Fastener Notice in Service Precautions.

3. Install motor/encoder mounting bolts.
^ Tighten the motor/encoder mounting bolts to 20 Nm (15 ft. lbs.).
4. Install the motor/encoder electrical connector.
5. Install the transfer case shield.
6. Lower the vehicle. Refer to Vehicle Lifting.