Operation CHARM: Car repair manuals for everyone.
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Wiper Motor Replacement

WIPER MOTOR REPLACEMENT

TOOLS REQUIRED
- J 39232 Wiper Transmission Separator
- J 39529 Wiper Transmission Installer

REMOVAL PROCEDURE




1. Remove the wiper arms.
2. Remove the air inlet grille panel.
3. Disconnect the transmission drive link from the wiper motor crank arm using the J 39232 .




4. Remove the wiper motor electrical connector.
5. Remove the three bolts.
6. Remove the wiper motor from the vehicle.

INSTALLATION PROCEDURE




1. Install the wiper motor on the vehicle.
2. Install the 3 bolts.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten
Tighten the 3 bolts to 7.0 N.m (62 lb in).

3. Connect the wiper motor electrical connector.




4. Connect the transmission drive link to the crank arm using the J 39529.

IMPORTANT: Assemble the wiper transmission to the crank arm past the second detent so that the seal is compressed to a maximum height of 25.5 mm (1.0 in).
Lubricate the inside of the socket with a lithium-based grease (GM P/N 1050109, 1052196 or equivalent).


5. Install the air inlet grille panel.
6. Install the wiper arms.