Brake Drum Replacement

BRAKE DRUM REPLACEMENT

Tools Required
^ J 41013 Rotor/Drum Flange Resurfacing kit
^ J 42450-A Wheel Hub/Flange Resurface kit


Removal Procedure





1. Raise and suitably support the vehicle.
2. Remove the rear wheel and tire assembly.

Notice: Do not pry against the splash shield or backing plate in attempt to free the drum. This will bend the splash shield or backing plate. A bent backing plate may cause brake chatter and/or pulsation.

3. Remove the brake drum.
4. If the brake drum is to be reinstalled to the vehicle use the J 41013 in order to clean any rust or corrosion from the hub/flange mating surface of the brake drum.
5. Use the J 42450-A in order to clean the wheel hub flange.


Installation Procedure

1. Adjust the drum brakes.
2. Install the brake drum.
3. Install the rear tire and the wheel assembly.
4. Apply the brakes approximately three times in order to seat the brake shoes against the drum.
5. Lower the vehicle.