Oil Cooler Pipe Seals Replacement

Oil Cooler Pipe Seals Replacement

^ Tools Required
- J 41239-10 Cooler Line Seal Remover.
- J 41239-1 Cooler Line Seal Installer.

Removal Procedure

Caution: Refer to Vehicle Lifting in Service Precautions.

1. Raise the vehicle. Support the vehicle.
2. Remove the transmission oil cooler pipes from the transmission.





3. Remove the cooler pipe bracket stud.





4. Remove the oil cooler pipe seals.

Installation Procedure





1. Install the J 41239-1 on the transmission case using cooler pipe bracket stud hole.
2. Press the new seals in. Tighten the J 41239-1 until the seal bottoms out in the case bore.





3. Install the cooler pipe bracket stud.
4. Install the transmission oil cooler pipes.
5. Lower the vehicle.
6. Inspect the transmission fluid level.
7. Operate the engine for 2 or 3 minutes.
8. Inspect the transmission fluid level.