Seat Back Bolster Replacement - Rear Split Folding

SEAT BACK BOLSTER REPLACEMENT - REAR SPLIT FOLDING

REMOVAL PROCEDURE
1. Remove the rear seat cushion.




2. Remove the rear seat back bolster bolt (3) from the lower U-bracket.
3. Lift up the rear seat back bolster (2). Disengage the T-hook from the access hole in the rear shelf in order to remove the rear seat back bolster (2).

INSTALLATION PROCEDURE
1. Pull the shoulder belt away from the rear seat back bolster area.




2. Install the rear seat back bolster (2).
3. Position and engage the T-hook into the access hole in the rear shelf panel.
4. Pull forward on the top edge of the rear seat back bolster along the shelf panel in order to ensure that the attaching hook is properly engaged.
5. Install the rear seat back bolster bolt (3) into the lower U-bracket.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten
Tighten the bolster bolt to 12 N.m (106 lb in).

6. Install the rear seat cushion.