Camshaft Position Sensor: Service and Repair

REMOVAL PROCEDURE

Locations View:

1. Turn OFF the ignition.
2. Remove the power steering pump.
3. Disconnect the sensor electrical connector.
4. Remove the attaching bolt.
5. Remove the sensor.
6. Inspect the sensor O-ring for wear, cracks or leakage if the sensor is not being replaced.

INSTALLATION PROCEDURE
1. Lubricate the O-ring with clean engine oil. Replace the O-ring if the O-ring is damaged.

Locations View:

2. Install the camshaft position sensor.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten
Tighten the retaining bolt to 8 N.m (71 lb in).

3. Connect the sensor electrical connector.
4. Install the power steering pump.