Outer

Tie Rod End Replacement - Outer

^ Tools Required
- J 24319-B Universal Steering Linkage Puller

Removal Procedure

Important: Use the J 24319-B in order to separate all the tie rod ends.





1. Remove the tire and wheel.
2. Remove the nut (5) from the outer tie rod ball stud (4).
3. Loosen the jam nut (2).





4. Use the J 24319-B in order to remove the outer tie rod ball stud from the steering knuckle.
5. Remove the tie rod end (4) from the shaft (1).





6. Inspect the inner tie rod shaft (1) for bending or damaged threads.
7. Clean the tapered surface of the steering knuckle (6).

Installation Procedure





1. Install the tie rod end (3) to the inner tie rod shaft (1).
2. Install the outer tie rod ball stud (4) to the steering knuckle (6).

Notice: Refer to Fastener Notice in Service Precautions.

3. Install the new prevailing torque nut (5) to the outer tie rod ball stud (4).
^ Tighten the new prevailing torque nut to 20 Nm (15 ft. lbs.), then 180 degrees rotation.
4. Install the tire and wheel.
5. Adjust the front toe.
6. Tighten the jam nut (2).
^ Tighten the jam nut to 75 Nm (55 ft. lbs.).