Inflatable Restraint Instrument Panel Module Replacement

REMOVAL PROCEDURE




1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 5.

CAUTION:
- A deployed dual stage inflator module will look the same whether one or both stages were used. Always assume a deployed dual stage inflator module has an active stage 2. Improper handling or servicing can activate the inflator module and cause personal injury.
- Refer to SIR Caution in Service Precautions.
- Refer to SIR Inflator Module Handling and Storage Caution in Service Precautions.

2. Remove the instrument panel (I/P) upper trim pad.
3. Remove the connector position assurance (CPA) from the yellow 2-way wiring harness connector on the inflatable restraint I/P module.
4. Disconnect the harness connector from the I/P module.




5. Remove the I/P module mounting fasteners (3).
6. Remove the I/P module (1) from the cross-car beam (2).
7. Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required retention period. Refer to Inflator Module Handling and Scrapping.

INSTALLATION PROCEDURE




1. Install the I/P module (1) to the cross-car beam (2).
2. Install the I/P module mounting fasteners (3).

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten
Tighten fasteners to 10 N.m (89 lb in).




3. Connect the yellow 2-way wiring harness connector to the I/P module.
4. Install the CPA to the wiring harness connector.
5. Install the I/P upper trim pad.
6. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 5.