Front Door Window Glass: Service and Repair

Window Replacement - Front Door (Monte Carlo)

Removal Procedure

1. Position the front door window in the full down position.
2. Remove the front door inner trim panel.
3. Remove the front door water deflector.
4. Remove the front door outer belt sealing strip.
5. Remove the front door window weatherstrip.




6. Remove the front door window to the front door window regulator bolts.




7. Remove the window from the outside of the front door.

Installation Procedure




1. Position the front door window between the inner and the outer door panels.
2. Point the lower front corner of the front door window down and pass through the belt opening.
3. Align the edges with the front door window weatherstrip channel.
4. Turn the front door window to a horizontal position and align the holes in the window with the holes in the regulator.

Notice: Refer to Fastener Notice in Service Precautions.

Important: Install the forward front door window regulator bolt first.




5. Install the front door window to the front door window regulator bolts.

Tighten the front door window to regulator bolts to 10 N.m (89 lb in).

6. Install the front door window weatherstrip.

Important: Ensure that both sealing lips on the outer belt sealing strip are not rolled over and pointing downwards. If this condition is present the window will not raise properly.

7. Install the front door inner belt sealing strip.
8. Install the front door water deflector.
9. Install the front door inner trim panel.