Brake Pressure Modulator Valve (BPMV) Bracket Replacement
Brake Pressure Modulator Valve (BPMV) Bracket ReplacementRemoval Procedure
1. Turn the ignition switch to the OFF position.
2. Remove the Brake Pressure Modulator Valve (BPMV) (4) and the Electronic Brake Control Module (EBCM) (1) as an assembly from the lower BPMV bracket (3).
3. Remove the three lower BPMV bracket nuts attaching the lower BPMV bracket (3) to the wheel housing.
4. Remove the lower BPMV bracket (3) from the vehicle.
Installation Procedure
1. Install the lower BPMV bracket (3) to the wheel house.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the three BPMV bracket nuts to the studs on the lower BPMV bracket (3).
^ Tighten the three BPMV bracket nuts to 10 Nm (7 ft. lbs.).
3. Install the BPMV and EBCM as an assembly to the lower BPMV bracket (3).
4. Perform the ABS Automated Bleed Procedure.