Installing Engine Support Fixture

Engine Support Fixture

^ Tools Required
- J 28467-B Universal Engine Support Fixture
- J 28467-6A Bracket Assembly
- J 28467-7A Bolt Hook
- J 28467-8A Hook Assembly
- J 28467-34 Lift Hook Wing Nut and Washer
- J 28467-500 Engine Support Fixture
- J 28467-500UPD Utility Straps

Installation Procedure
1. Remove the right side engine mount strut.





2. Install the J 28467-500.





3. Install the spreader bar to the engine mount strut bracket.





4. Install the spreader bar to the engine right side engine lift hook.
5. Install the J 28467-6A.





6. Install the J 28467-7A to the engine left side engine lift hook.
7. Install the J 28467-34.
8. Install the J 28467-6A.





9. Install the J 28467-8A to the spreader bar.
10. Install the J 28467-34.





11. The engine support fixture upper portion installed.

Important: Perform the following steps only if you are disconnecting both of the powertrain mounts from the frame or the powertrain.

12. Raise and support the vehicle. Refer to Vehicle Lifting.

Caution: The utility straps MUST be installed in order to prevent forward movement of the powertrain. If the utility straps are not installed, the powertrain will move which may cause personal injury and vehicle damage.





13. Install the J 28467-500UPD to the engine.





14. Install the J 28467-500UPD opposite end to the underbody rail.





15. Install the OTHER J 28467-500UPD to the transaxle.
16. Install the J 28467-500UPD opposite end to the underbody rail.





17. Tighten both of the J 28467-500UPD utility straps in order to prevent forward movement of the powertrain.

Removal Procedure
1. Remove both of the J 28467-500UPD.
2. Lower the vehicle.
3. Remove the J 28467-34.
4. Remove the J 28467-7A.
5. Remove the J 28467-6A.
6. Remove the J 28467-34.
7. Remove the J 28467-8A.
8. Remove the J 28467-6A.
9. Remove the J 28467-500.
10. Install the right side engine mount strut.