Transmission Fluid Replacement
Transmission Fluid ReplacementDraining Procedure
1. Raise and support the vehicle.
2. Clean away all dirt and debris from the transmission fluid drain plug area.
3. Position an appropriate container under the transmission.
4. Remove the transmission fluid drain plug and washer. Discard the washer. Allow the transmission fluid to drain into the container.
Notice: Refer to Component Fastener Tightening Notice in Service Precautions.
5. Install the transmission fluid drain plug and NEW washer.
^ Tighten the drain plug to 37 Nm (27 ft. lbs.).
6. Remove the container used to catch the used transmission fluid from under the vehicle.
Filling Procedure
1. Clean away all dirt and debris from the transmission fluid fill plug area.
2. Remove the transmission fluid fill plug and washer. Discard the washer.
3. Fill the transmission to just below the bottom of the fill plug hole with the recommended fluid.
4. Install the transmission fluid fill plug and NEW washer.
^ Tighten the fill plug to 37 Nm (27 ft. lbs.).
5. Lower the vehicle.