Bose Module Replacement

BOSE MODULE REPLACEMENT

REMOVAL PROCEDURE




1. Remove the front floor kick-up panel.
2. Remove the cover from theinstrument panel (IP) electrical center.
3. Remove the RDO/ANT MiniFuser #24 from the IP electrical center.
4. Remove the IP left lower insulator panel.
5. Disconnect the electrical/audio connector from the Boser signal processing module.




6. Remove the bolts retaining the Boser signal processor to the steering column bracket.

IMPORTANT: The signal processing module is only held in place by retaining bolts. Be sure to support the signal processor upon removal of the bolts.

7. Remove the signal processing module.

INSTALLATION PROCEDURE




1. Install the Boser signal processing module into position on the steering column bracket.
2. Install the Boser signal processing module retaining bolts.

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten
Tighten the Boser signal processing module retaining bolts to 2.5 N.m (22 lb in).




3. Connect the electrical/audio connector to the signal processing module.
4. Install the IP left lower insulator panel.
5. Install the RDO/ANT MiniFuser #24 to the IP electrical center.
6. Install the cover to the I/P electrical center.
7. Install the front floor kick-up panel.