Wipers Inoperative - One or More Modes
WIPERS INOPERATIVE - ONE OR MORE MODESTEST DESCRIPTION
Step 1:
Steps 2-4:
Steps 5-7:
Steps 8-14:
Steps 15-16:
The numbers below refer to the step numbers on the diagnostic table.
5. This step tests for continuity through the 390 Ohms. resistor in the windshield wiper/washer switch.
6. This step tests for continuity through the delay resistors in the windshield wiper/washer switch. The measured resistance will change in sequence from low to high as the delay speed is increased.