Crankshaft Main Bearing

Crankshaft Main Bearing Bore Diameter 64.068-64.082 mm (2.5224-2.5229 inch)
Block
Cylinder Bore Diameter 85.992-86.008 mm (3.3855-3.3861 inch)
Cylinder Bore Out-of-Round - Maximum 0.010 mm (0.0004 inch)
Cylinder Bore Taper - Maximum 0.010 mm ( 0.0004 inch)





NEW Crankshaft Bearing bolts in sequence finger tight.
Tighten the crankshaft bearing bolts in sequence.
Tighten the crankshaft bearing bolts to 20 Nm (15 ft. lbs.)
Tighten the crankshaft bearing bolts in sequence using the J 36660-A.
Tighten the crankshaft bearing bolts 70 degrees using the torque angle meter.





Tighten the lower crankcase perimeter bolts in sequence.
Tighten the lower crankcase perimeter bolts to 25 Nm (18 ft. lbs.)