Manifold Pressure/Vacuum Sensor: Service and Repair

MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR REPLACEMENT

REMOVAL PROCEDURE




1. Disconnect the manifold absolute pressure (MAP) sensor electrical connector (2).




2. Using a slight rocking motion, while pulling straight up, remove the MAP sensor.

NOTE: Do not rotate or pry on the MAP sensor when removing. Damage to the MAP sensor or the intake manifold may result.

3. Inspect the MAP sensor seal for damage, replace the seal, if necessary.

INSTALLATION PROCEDURE




1. Install a NEW MAP sensor seal, if necessary.
2. Install the MAP sensor.




3. Connect the MAP sensor electrical connector (2).