Water-In-Fuel Sensor Replacement

WATER-IN-FUEL SENSOR REPLACEMENT

REMOVAL PROCEDURE




1. Drain the fuel from the fuel filter. Refer to Water-in-Fuel Draining Procedure.
2. Remove the right front wheelhouse panel.
3. Disconnect the fuel filter electrical connectors.




4. Remove the water-in-fuel sensor (3) from the fuel filter (2).

INSTALLATION PROCEDURE

IMPORTANT: The water-in-fuel sensor must ONLY be tightened by hand.




1. Install the water-in-fuel sensor (3) to the fuel filter (2).




2. Connect the fuel filter electrical connector.
3. Install the right front wheelhouse panel.
4. Prime the fuel system. Refer to Fuel System Priming.
5. Start the engine. If the engine stalls, repeat the above step.
6. Once the engine starts, inspect for fuel leaks.