Center Sliding Door Roller: Service and Repair

Roller Bracket Replacement - Center

Removal Procedure

1. Remove the center roller track cover. Refer to Center Track Cover Replacement - Sliding Door () .




2. Position the sliding door inward for door clearance.
Remove the bolts (5) that retain the center roller bracket (2) to the door.
3. Disconnect the retaining spring located around the pin in order to release.
4. Support the sliding door at the bottom rear corner.
5. Slide the bracket rearward.
6. Remove the bracket (2) from the center roller track.



Installation Procedure

1. Install the bracket (2) to the center roller track.
2. Slide the bracket forward.
3. Remove the support from the sliding door.
4. Push the retaining pin back in place.
5. Check the retaining spring located around the pin for damage. If damaged, replace the spring.

Notice: Refer to Fastener Notice in Cautions and Notices.





6. Install the bolts (5) that retain the center roller bracket to the door.

Tighten the center roller bracket retaining bolts to 35 N.m (26 lb ft).

7. Install the center roller track cover. Refer to Center Track Cover Replacement - Sliding Door () .