71. Converter Housing Installation

Converter Housing Installation

^ Tools Required
- J 41510 T-50 Plus Bit





Important: Ensure converter housing and case face are clean before installing new pump seal.

1. Install the oil pump seal (5). Seat oil pump seal (5) by hand, between pump body and case. Ensure the seal is evenly seated.
2. Install the converter housing (102).

Notice: Refer to Fastener Notice in Service Precautions.

3. Install the converter housing bolts (94) to the transmission case. Use the J 41510.
^ Tighten converter housing bolts evenly in a star pattern sequence.
^ Tighten the converter housing bolts (94) to 65 - 75 Nm (48 - 55 lb ft).