Lubricant Level Inspection

Lubricant Level Inspection - Front Drive Axle





1. Raise the vehicle.
2. Ensure the vehicle is level.
3. Clean the area around the front axle fill plug.
4. Remove the front axle fill plug and the washer.
5. Inspect the oil level. Specification The oil level should be between 0 - 13 mm (0 - 0.5 inch) below the fill plug opening.
6. If the level is low, add oil until the level is even with the bottom edge of the fill plug opening. Use the proper fluid.

Notice: Refer to Fastener Notice in Service Precautions.

7. Install the fill plug and the washer.
^ Tighten the plug to 33 Nm (24 ft. lbs.).
8. Lower the vehicle.