Clutch Assembly Replacement

Clutch Assembly Replacement

^ Tools Required
- J 36660-A Torque Angle Meter

Removal Procedure





1. Remove the transmission.
2. Remove the clutch pressure plate bolts (1). Discard the bolts.
3. Remove the clutch pressure plate (2) and driven disc (3) from the dowel pins (4) on the flywheel (5).

Installation Procedure





1. Install the clutch pressure plate (2) and driven plate (3) to the dowel pins (4) on the flywheel (5).
2. Install the clutch pressure plate bolts (1) finger tight.
3. Use the Snap-On A145 Clutch Aligner Set, or equivalent, to align the clutch driven plate (3) to the clutch pilot bearing.

Pressure Plate Tightening Sequence:

Notice: Refer to Fastener Notice in Service Precautions.

4. Tighten the NEW clutch pressure plate bolts in the sequence shown.
4.1. Tighten the clutch pressure plate bolts in sequence to 20 Nm (15 ft. lbs.).
4.2. Use the J 36660-A in order to tighten the clutch pressure plate bolts in sequence an additional 45 degrees.
5. Install the transmission.