2. Crankshaft Balancer Removal

Crankshaft Balancer Removal

^ Tools Required
- J 41816 Crankshaft Balancer Remover
- J 41816-2Crankshaft End Protector
- J 42386-A Flywheel Holding Tool





1. Notice: Refer to Fastener Notice in Service Precautions.

Important:
^ Do not use the crankshaft balancer bolt again. Install a NEW crankshaft balancer bolt during final assembly.
^ Ensure the teeth of the flywheel holding tool mesh with the teeth of the engine flywheel.

Install the J 42386-A and bolts. Use one M10 - 1.5 x 120 mm and one M10 - 1.5 x 45 mm bolt for proper tool operation.
Tighten the J 42386-A bolts to 50 Nm (37 ft. lbs.).





2. Remove the crankshaft balancer bolt. Do not discard the crankshaft balancer bolt. The balancer bolt will be used during the balancer installation procedure.





3. Use the J 41816 and the J 41816-2 in order to remove the crankshaft balancer.
4. Remove the J 42386-A and bolts.