Memory Seat Control Module Replacement

MEMORY SEAT CONTROL MODULE REPLACEMENT

REMOVAL PROCEDURE




1. Remove the seat cushion.
2. Disconnect the upper electrical harness connectors (3).
3. Remove the module (2) retaining screws (1).
4. Slide the module to the right to disengage the lower retainers.




5. Disconnect the lower electrical harness connectors (2).
6. Remove the module from the vehicle.

INSTALLATION PROCEDURE




1. Position the module into the vehicle.
2. Connect the lower electrical harness connectors (2).




3. Slide the module (2) to the left to engage the lower retainers.
4. Install the module retaining screws (3).

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten the screws to 3 N.m (26 lb in).

5. Connect the upper electrical harness connectors (3).
6. Install the seat cushion.
7. If a new memory seat module was installed, calibrate the seat. Refer to Memory Seat Calibration Procedure.