Support Cable Replacement - Endgate

Support Cable Replacement - Endgate

Removal Procedure

1. Lower the end gate.




2. Remove the end gate support cable on each side from the cable restrain bolt.




3. Remove the retainer from the end gate striker.
4. Remove the end gate support cable from the end gate.

Installation Procedure




1. Install the end gate support cable onto the end gate.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the latch fastener.

Tighten the latch fasteners to 25 N.m (18 lb ft).




3. Install the end gate support cable onto cable restraint fastener.
4. Close the end gate.