Switch Replacement - Hot and Cold Cupholder

SWITCH REPLACEMENT - HOT AND COLD CUPHOLDER

REMOVAL PROCEDURE
1. Remove the cupholder assembly.




2. Disconnect the wire connectors from the 2 switches.
- Switch 1 is the power switch.
- Switch 2 is the hot and cold switch.

IMPORTANT: Observe the orientation of the switches. The red lights points towards the rear of the vehicle.




3. Remove the defective switch by pushing in the retaining tabs (1) while pushing the switch outwards.

INSTALLATION PROCEDURE




1. Install the new switch until the tabs (1) clicks in place. Ensure the red light is pointing rearward of the vehicle.




2. Connect the electrical connectors.
3. Install the cupholder assembly to the console.